Bit late now, the chain saw may have done its job, but on the 461 the compressor is in the bilge adjacent to the cooker area. Secondly a tool I can heartily recommend for this sort of work, link below. I use this for any fine joinery job where a thin controlled cut is needed, it is absolutely brilliant. The good thing about it is you can start at any point and go in to any depth, cut out the shape you want and no extra saw kerf around the sides. FINE also do one, but out of my budget.

Download now any manual for MODE D EMPLOI ISOTHERM 3000. How to program a Honeywell Pro 3000 Thermostat, a step by step guide. Davey Suicide Download Chrome on this page. How to enter thermostat into installer.

There is also a similar unit made by CEL (see Amazon) but I don't know how good it is. Good luck, Graeme. Thanks Graeme, the job is done, the mistake is found.

The cable connector which lay under the compressor in the bilge (!) was corroded (it should have been hung up) The ugly part part was the sawing and now we will have to put a mahagony playwood cover over it. Thanks to the fast response of Hanse After Sales we knew on which side to drill. Bakugan Sub Indonesia. The electrician doing the job couldn't believe his eyes that Hanse forgot to make this inspection door.

The models 2008/09 have this hatch now. A weak consolation!

Edited by tobo - 08 February 2011 at 13:21.